Fix Sliding Wooden Door Off Track

Moving the door when the back side is sliding on the ground is a little difficult.

Fix sliding wooden door off track.

Use an aerosol lubricant to lubricate all the door rollers. Remove any remaining staples with pliers. To replace torn or cracked weatherstripping where the sliding and fixed panels overlap loosen its staples with a flathead screwdriver then grab one end and pull it and the staples off the door prying gently with a putty knife. Hope this video.

Http amzn to 2eijbrx dry spray lubricant http goo gl 4eydkq click link to order sliding door lubricant. If one side looks lower raise it until the door looks even on the track photo 1. Afterwards place another block of wood onto the track perpendicular to the first block and use a hammer to hit the top of the second piece of wood. Use a wire brush to clean off the dirt or debris.

If a malfunctioning sliding door is a chronic problem see if the track is dirty. If the rollers are damaged install replacement rollers available at home centers. Bring the door to within a few inches of the strike side jamb. Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.

If you notice the track is uneven with the floor place a block of wood into the left or right side of the track parallel to the its direction. Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track. Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track. Straighten the track with a block of wood if it s bent.

Depending on your door type locate the brace that holds the wheel roller on the side that is sagging. Built up dirt or loose debris can cause a door to stop sliding and ride off the track. This is a video to show you all how to repair a sliding cavity pocket door which may be stuck no rolling properly or not locking correctly. Use the blade of an old screwdriver to pry stubborn dirt loose.

Using a screwdriver you can just adjust the mounting screw. To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks. Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws. Don t worry it ll be the only screw you see there.

You can then fix the problem of your closet doors jumping off their track. Learn how to get your sliding door back in the tr. Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side.