In addition to cleaning and lubricating sliding door tracks you want to lubricate the door lock.
Fix loose sliding door lock.
Donations appreciated click in upper right corner info circle.
Remove the handles from the door using a philips head screwdriver.
Built up dirt or loose debris can cause a door to stop sliding and ride off the track.
Use a wire brush to clean off the dirt or debris.
Step 3 removing the screws two screws on the end of the door secure the latch.
Tighten the screws with a phillips head screw driver.
I always said that i was going to replace it but never got around to it.
I can be lazy sometimes but c mon.
Ok since we have moved into this house we have had this loose handle on the sliding glass door that goes out to the porch.
Using an awl or small screwdriver push the button in all the way and at the same time pull off the handle.
It did not latch shut.
Insert the graphite pen into the lock and squeeze some lubricating substance into the latch to dislodge anything inside.
Apply a lubricant to both upper and lower tracks to keep the door hardware clean and operating freely.
If it won t lock open the door.
The best way to lubricate any lock is to disassemble it and use an aerosol lubricant to flush away grime and coat the moving parts of the lock.
It s an easy fix.
If a malfunctioning sliding door is a chronic problem see if the track is dirty.
Then replace the bottom screw in the hole where it was affixed to the handle to prevent the latch from falling into the doorframe.
This sliding glass door lock was not working.
If it is loose or has slipped out of the mortise place it back in the mortise and tighten the screws with a phillips screwdriver.
Place the interior side of the door lock frame into the door.
These types also experience the same symptoms as the standard glass door locks.
Remove the door rose by inserting a small screwdriver into the small notch in the rose and twisting the tool to pop it off.
It s been over two years now and i suppose enough is enough.
Place the door handle over the screw holes on the interior side of the door frame followed by the screws and hand tighten the screws.
Sometimes the sliding door may have a latch that works by sliding a small notch up and down.
