Fitting A Door Handle And Latch

Fitting door handles may appear complicated at first but it is an easier task then you think.

Fitting a door handle and latch.

Insert the latch into the side of the door to see if its faceplate sits flush to the door. With the latch securely fitted to the door it s now time to get the handles fitted. Use masking tape to secure the door handle kit s template to the door at this spot. Follow our handy guide to fitting interior door handles.

Pick one side of the door to start on either side is fine. Step by step instructions including the tools needed measuring out creating a mortice and fitting the tubular latch in the right place for your door handle. Put your tape measure on the floor in front of your door and measure up 41 inches from the floor since this is the most common placement for door handles. The handle or knob must be jiggled to unstick the latch.

Installing a door handle is a relatively easy home project that you can do with a pre made kit. Door latch screwed up firmly on to door. The normal height for fitting a mortice latch is a metre up from the floor around 3 feet but you can either match existing handle heights ask the client how high they want them or check the drawing schedule to find out which height to drill the handles. The latch plate can now be fitted to the door frame.

Use the sharp chisel and the hammer to chisel out a hole for the latch. Before you can fit a door handle to a new door you will first need to mark regions to be drilled and cut. Step by step guide to fitting a mortice latch door handles. Mark your brand new door with the location.

Establish the handle height and mark the door. The cuts made with the utility knife are your guidelines as to where to stop chiselling. Pop the spindle door bar through the spindle holes so that it is roughly centrally aligned and then push a handle over it. Make sure that.

Measure the distance as shown in fig 3 as a and transfer this measurement to the door frame position the latch plate in what will be its fixed position and mark out the door frame for the recess and any hole that will be required for the latch tongue when. Also chisel inside the hole for the latch to fit. Close the door to and mark the centre of the latch tongue on the door frame. Marking the door handle positions.

The door latch is not extended before rotating the knob. Once the door is open try to actuate the door latch with the handle.